ES OPTRONICS LIMITED
ES OPTRONICS LIMITED
Add to Cart
AUO Industrial LCD Display , G185HAN01 0 Industrial PC Monitor 18.5 Inch Antiglare
Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when handling.
7) Do not open or modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after it was taken out from the container, do not press the center of LED lightbar edge. Instead, press at the far ends of the LED light bar edge softly. Otherwise the TFT Module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the Interface Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure, do not twist nor bend the TFT Module even momentarily. While designing the enclosure, it should be taken into consideration that no bending/twisting forces are applied to the TFT Module from outside. Otherwise the TFT Module may be damaged.
12) Small amount of materials having no flammability grade is used in the LCD module. The LCD module should be supplied by power complied with requirements of Limited Power Source (IEC60950-1 or UL60950-1), or be applied exemption.
AUO G185HAN01.0 General Features
| Brand | AUO | Model | G185HAN01.0 |
|---|---|---|---|
| Diagonal Size | 18.5 inch | Type | a-Si TFT-LCD , LCM |
| Pixel Format | 1920(RGB)×1080 [FHD] | Configuration | RGB Vertical Stripe |
| Active Area | 409.8(H)×230.4(V) mm | Outline Dim. | 430.4(H)×254.6(V) ×12.5(D) mm |
| Bezel Area | 410.96(H)×232.0(V) mm | Treatment | Antiglare, Hard coating (3H) |
| Luminance | 350 cd/m² (Typ.) | Contrast Ratio | 1000:1 (Typ.) (TM) |
| View Direction | Symmetry | Response Time | 10/10 (Typ.)(Tr/Td) |
| Viewing Angle | 89/89/89/89 (Typ.)(CR≥10) | Operating Mode | AHVA, Normally Black, Transmissive |
| Support Color | 16.7M (sRGB) | Light Source | WLED , 50K hours , With LED Driver |
| Weight | 1.20Kgs (Typ.) | Designed For |
|
| Frame Rate | 60Hz | Touch Panel | Without |
| Interface Type | 30 pins LVDS (2 ch, 8-bit) , Connector | ||
| Power Supply | 5.0V (Typ.) | ||
| Environment | Operating Temperature: -20 ~ 70 °C ; Storage Temperature: -20 ~ 70 °C | ||
AUO G185HAN01.0 Backlight Features
| Back-light Features: | Type | Position | Life(Hours) | Amount | Shape | Replacement |
|---|---|---|---|---|---|---|
| WLED | Edge light type | 50K(Typ.) | - | - | - | |
| Interface Features : | WLED Driver State | Physical Type | Interface Position | |||
| With LED Driver | Connector |
| ||||
| Interface Detail | Brand Name | Model Name | Amount | Pins | Pin Pitch | Pin Configuration |
| E&T | 3808K-F05N-12R | 1 pcs | 5 pins | 1.25 mm |
| |
| WLED Driver Electrical : | Input Voltage | Input Current | Power Consumption | |||
| 12.0±1.2V | 1.04A (Typ.) | 12.5/13.6W (Typ./Max.) | ||||
OTHER AUO Industrial LCD PANEL
| Panel Model | Brand | Type | Component | Size | Resolution | General Grade | Bright Dot Rate |
| G065VN01 V2 | AUO | a-Si TFT-LCD | LCM | 6.5 | 640×480 | A Grade | 100% ZBD |
| G070VW01 V0 | AUO | a-Si TFT-LCD | LCM | 7 | 800×480 | A Grade | 100% ZBD |
| G084SN05 V9 | AUO | a-Si TFT-LCD | LCM | 8.4 | 800×600 | A Grade | 100% ZBD |
| G101EVN01.0 | AUO | a-Si TFT-LCD | LCM | 10.1 | 1280×800 | A Grade | 100% ZBD |
| G215HVN01.0 S03 | AUO | a-Si TFT-LCD | LCM | 21.5 | 1920×1080 | A Grade | 100% ZBD |